SAM9-L9260 Hacking: Difference between revisions
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
5) run lsusb, and look for 'Bus 004 Device 007: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port' | 5) run lsusb, and look for 'Bus 004 Device 007: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port' | ||
5) if that exists, go into the SAM-BA directory, and run ./sam-ba. You should be able to select /dev/ttyUSB0 and connect to it. | 5) if that exists, go into the SAM-BA directory, and run ./sam-ba. You should be able to select /dev/ttyUSB0 and connect to it. | ||
== Linux Development Enviroment setup == | |||
(for Gentoo (Gentoo) Gentoo Crossdev works. See http://www.rockbox.org/wiki/CrossCompiler) | |||
1) download rockbox source "svn co svn://svn.rockbox.org/rockbox/trunk/tools rockbox_tools" | |||
2) run 'rockbox_tools/rockboxdev.sh' it will ask for a target, select arm as your target by pressing 'a' when prompted. | |||
3) When build is done, edit .bashrc so that it includes PATH=$PATH:/usr/local/arm-elf/bin | |||
4) get the lyre project source code (as test/reference for SAM9 | |||
can be fetched via 'hg clone http://lyre.hg.sourceforge.net:8000/hgroot/lyre/lyre lyre_src' | |||
Revision as of 01:00, 23 September 2009
A couple of SAM9 Boards are around the space (see http://www.olimex.com/dev/sam9-L9260.html for spec's).
Bootloader:
Mac:
1) Give up on OSX. IT won't work properly, I tried. Well, you can try too, but I found another way... 2) Load linux on your mac. Rock on! 3) Download 'SAM-BA_CDC.zip (Linux - v1.13 current release) (7 MB, revision 1.13, updated 6/09)' from http://www.atmel.com/dyn/products/tools_card.asp?tool_id=3883 4) Unzip that package somewhere helpful. Connect your USB -> Serial connector , and connect your serial to the board. 5) run lsusb, and look for 'Bus 004 Device 007: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port' 5) if that exists, go into the SAM-BA directory, and run ./sam-ba. You should be able to select /dev/ttyUSB0 and connect to it.
Linux Development Enviroment setup
(for Gentoo (Gentoo) Gentoo Crossdev works. See http://www.rockbox.org/wiki/CrossCompiler) 1) download rockbox source "svn co svn://svn.rockbox.org/rockbox/trunk/tools rockbox_tools" 2) run 'rockbox_tools/rockboxdev.sh' it will ask for a target, select arm as your target by pressing 'a' when prompted. 3) When build is done, edit .bashrc so that it includes PATH=$PATH:/usr/local/arm-elf/bin 4) get the lyre project source code (as test/reference for SAM9
can be fetched via 'hg clone http://lyre.hg.sourceforge.net:8000/hgroot/lyre/lyre lyre_src'
